Month: December 2022

These devices contain four independent 2-input exclusive-OR gates. They perform the Boolean functionY = A 􀀀 B or Y = AB + AB in positive logic.A common application is as a true/complement element. If one of the inputs is low, the other input is reproducedin true form at the output. If one of the inputs[...]

FEATURES• High isolation voltage (BV = 5 000 Vr.m.s.)• High collector to emitter voltage (VCEO = 80 V)• High-speed switching (tr = 3 ms TYP., tf = 5 ms TYP.)• Ordering number of taping product: PS2501L-1-E3, E4, F3, F4, PS2501L-2-E3, E4• UL approved: File No. E72422 (S) APPLICATIONS• Power supply• Telephone/FAX.• FA/OA equipment• Programmable logic[...]

Low NoiseNo External Components RequiredReplaces Chopper Amplifiers at a LowerCostSingle-Chip Monolithic FabricationWide Input Voltage Range0 to ±14 V TypWide Supply Voltage Range±3 V to ±18 VEssentially Equivalent to Fairchild mA714Operational Amplifiers These devices represent a breakthrough in operational amplifier performance. Low offset and long-term stabilityare achieved by means of a low-noise, chopperless, bipolar-input-transistor amplifier circuit.[...]

The NE5532Pare high-performance operational amplifiers combining excellentdc and ac characteristics. They feature very low noise, high output-drive capability, high unity-gain andmaximum-output-swing bandwidths, low distortion, high slew rate, input-protection diodes, and outputshort-circuit protection. These operational amplifiers are compensated internally for unity-gain operation. Thesedevices have specified maximum limits for equivalent input noise voltage. · Equivalent Input Noise[...]

5G6515 ,The center frequency input D et ec to r (D et EC to R) in G6515 inputs the signal in the passband through a comparator.Enter the frequency selection part of the subtraction counter for frequency selection. It is mainly used to detect the frequency of the input signal or narrow the width of the[...]

High-Frequency, Regulated,200mA, Inverting Charge Pump Description TheMAX889TESA+T inverting charge pump delivers a regulatednegative output voltage at loads of up to 200mA. Thedevice operates with inputs from 2.7V to 5.5V to producean adjustable, regulated output from -2.5V to -VIN.The MAX889TESA+T is available with an operating frequency of2MHz (T version), 1MHz (S version), or 0.5MHz (R version).The[...]

Single Supply or Dual Supplies Wide Range of Supply Voltage Max Rating …2 V to 36 V Tested to 30 V . . . Non-V Devices Tested to 32 V … V-Suffix Devices Low Supply-Current Drain Independent of Supply Voltage  0.4 mA Typ Per ComparatorLow Input Bias Current     25 nA Typ Low Input Offset Current[...]

The LM137/LM337-N are adjustable 3-terminal negative voltage regulators capable of supplying in excess  of  −1.5A  over  an  output  voltage  range  of−1.2V  to  −37V.  These  regulators  are  exceptionally easy to apply, requiring only 2 external resistors to set the output voltage and 1 output capacitor fo frequency compensation. The circuit design has been optimized for excellent[...]

description Low Input Bias Current . . . 50 pA Typ Low Input Noise Current0.01 pA//Hz Typ Low Input Noise Voltage . . . 18 nV//Hz Typ Low Supply Current . . . 3.6 mA Typ High Input Impedance . . . 1012 W TypInternally Trimmed Offset Voltage Gain Bandwidth . . . 3 MHz[...]

Dual Retriggerable Monostable Multivibrators (with Clear) This d-c triggered multivibrator features output pulse width control by three method. The basic pulse time isprogrammed by selection of external resistance and capacitance values. Once triggered, the basic pulse width may beextended by retriggering the gated low-level -active (A) or high-level active (B) inputs, or be reduced by[...]